Nanoporous TiO2 solar cells sensitised with a fluorene-thiophene copolymer

P. Ravirajan, S. A. Haque, D. Poplavskyy, J. R. Durrant, D. D.C. Bradley, J. Nelson

Research output: Chapter in Book/Report/Conference proceedingConference contribution

53 Scopus citations


Composites of nanostructured metal oxides with conjugated polymers are promising material combinations for efficient solar energy conversion. However, performance of such combinations is normally limited by the low interfacial area of planar structures and poor charge carrier mobility of the polymer. In this study, we focus on TiO2 with a high hole-mobility polymer, poly (9,9′-dioctylfluorene-co-bithiophene) (F8T2). Transient optical spectroscopy confirms that efficient photo-induced electron transfer occurs from F8T2 to TiO2 in both planar TiO2/F8T2 structures and in high surface area, porous TiO2/F8T2 structures. Recombination between the positive polaron in the polymer and electron in the TiO2 is remarkably slow (~ms) in both cases. The influence of layer thickness and surface morphology on cell performance was examined. The best cell was made with reduced layer thickness and increased surface morphology and offered an external quantum efficiency of 11.5% and monochromatic power efficiency of 1 at.% 440 nm. This cell produced an open circuit voltage Voc of 0.80 V and a short circuit current density of approximately 300 μA/cm2 under simulated air mass (AM) 1.5 illumination. However, the power conversion efficiency is limited by a poor fill factor, which is attributed to an energy barrier at the polymer/metal interface. We investigate this problem using alternative polymer and top contact metals. © 2003 Elsevier B.V. All rights reserved.
Original languageEnglish (US)
Title of host publicationThin Solid Films
StatePublished - Mar 22 2004
Externally publishedYes


Dive into the research topics of 'Nanoporous TiO2 solar cells sensitised with a fluorene-thiophene copolymer'. Together they form a unique fingerprint.

Cite this